Recent content by Lloyd Williams

just a thought check the parking brake?

take oil line off either plug with cap or sillicone. i dint leave the oil line on just silliconed the hole on the carb and everything is fine. u could plug the carb with sillicone then attach oil tube and pump with sillicone and cut to desired length

http://www.blasterforum.com/do-yourself-20/injector-block-off-clean-3-a-31229/ that link should help more than i can :-) let me now how u get off

the white gear wil just spin freely on its own will not cause any damage, leave about 5cm on the pipes coming off the oil pump, the rest u can bin. the hole u plug on the carb is on the right side of the carb if i can remeber right. its where the oil would have got pumped into the carb from the...

if ur in ireland try ajsutton has ever stock blaster part google AJ SUTTON hope it helped

hi i have just done this too my blaster, i plugged the pipes with sillicone then inserted screws into the tubes while sillicone was wet just to be extra safe. dont for get to plug the hole where the oil would have gone into the carb with a little sillicone also allow the sillicone 24 hours...

i think ive found the problem snapped reed. im trying to find a place to buy new reeds any one now any sites? also will boyseen reeds or any after market reeds fit the stock reed cage and if so will i need to rejet my carb? thanks.I:I

ok thanks allot ill let u now how it goes tomorro night as soon as it done if its not fixed ill upload a vid an show u and see what you think :)

im going to try and take of the carb on my blaster tomorro and give it a clean, check the reeds see if their cracked or damaged. managed to start it after about 4 kicks with the choke out its idling nice and reving nice with choke out wen i put the choke back in it will rev up but its still got...

also how do i check too see if the tors is connected all ive learnt so far is that the tors is a shut off to do with throttle over ride is that correct

these are going to sound stupid questions but im not very mechanical but im learning by the day on this forum. how do u tell the jet sizes? what do i need for a compresion test and can i buy a kit to do it o summing? as far as the modding goes it got fatboy 2 exhaust paul turner expansion...

ok thanks im going to get a m8 to clean my carb out and check the jetting on sunday. im the type of guy who just pays to get stuff fixed my m8 going to show me how to clean the carb out as i thought maybe this might of been the problem as i was in deep bogs in my las ride. i have seen the diy...

i had the shop check over basically everything, is a 125ml to a gallon a lean mix i though this was adequit? the reason it went into the shop was when i swapped for the quad the guy saig ger it serviced its had been standindg a while, i didnt do this because we had 2 foot of snow and just...

i ride on the mountains not the roads. i have a trailer and tow to the mountain. in the uk espcially were i live off roading on the mountains is illegal only allowed on race tracks and theres only one and its 50 miles away and open 1nce a month weather permittred:(

the blaster was running better than ever wen it came outa the shop their normally really good and the quad sound nice and crisp the jets musta been fine or it woulda run like crap wouldnt have it????? it seems to rev ok for a few mins the boggy then crap what i mean is it will rev up but then it...