Recent content by Kyled07440

Ok so Ill order the reed cage and a new intake boot then. Hopefully it will run right after this. I feel like the reed cage has been the issue this whole time. Looks like it's been over tightened a few times.

By black this, I mean like the collar. Or whatever you'd call it.

So now I have another question. I want to get a need reed cage and intake boot because mine has seen better days. I think I want yo get the boysen dual stage set. Question is... Do you still use the intake boot or do you just use the black thing that it comes with? I don't want to order a new...

So I got the head and jug off today. The piston and cylinder look like new as far as I can tell, minus a little bit of black spot on top of the piston... The cylinder has no signs of scratches or anything. I'm kind of thinking some new rings and gaskets should take care of the compression. Only...

Yea I took the tank off, help the thumb throttle open and kicked it till the needle stopped. Did this a few times and it was 60 every time. I tried to start it prior to this too. It wouldn't start at first then like an hour later it started first kick. I talked to cosmetic gasket and they said...

Well, I have some bad news. I bought a compression tester and threw it in the blaster. Topped out at 60 psi lol. Can't believe it still ran like it did. But I have a Wiseco place right up the street so Im gonna call em and see if I can give em the cylinder and see if they can bore it out and...

Thanks for the advice. I did set the float level when I cleaned the carb. It may be a hair off. I also had to play with the idle screw and throttle cable a bit to get it to idle right. It seems to idle good. Maybe a little low at the moment till it warms up, but I've been making slow adjustments...

That's what I figured bit is there a top end kit you would suggest? I know Wiseco is good but do the sell a while top end kit with the cylinder? I'd like to avoid sending it out to get bored and honed if I can. Mainly because I'm not sure where around me would do that...

Ok, I figured I'd just get a new wire. But I have another question now. I'm seeing top end kits on ebay with the piston rings gaskets and a new jug for like 100 bucks. Should I stay away from that or would it be good to buy it. Just thinking it takes the hassle of sending out the top end to be...

That's what I was thinking. I wanted to get it running first to see how things were. And it runs pretty good when it's running. Only other problem I have is when I hit water it bogs down. I think I need to replace the plug wire and put some dielectric grease in it to solve that issue. Just...

Hey guys, I'm new to the site, and quads. I've used it to help fix up a blaster I purchased a few months ago but I just signed up so I can ask some questions I have and can't find the answers to. I bought the blaster and fixed some oil leaks it had. Did the oil pump delete, and removed the...