Recent content by frantz65

  1. F

    yamaha warrior frame help

    Yeh idk what the deal is with it. Ill put this 1 I got to the side and make a shelf out of it haha. I found a guy not far selling a frame through craigslist that is identical to mine so will be picking that up wednesday
  2. F

    yamaha warrior frame help

    The 1 I picked up as spare(not sure of year) the entire front end is different and no light mounts or anything. The bumber doesn't even mount to it
  3. F

    yamaha warrior frame help

    Yrh I figured thst but finding an exact year cheao isn't easy so trying to find out what years are compatible
  4. F

    yamaha warrior frame help

    My 01 frame has bsd frame and read somewhere elsr all frames will work. So I picked up a frame unsure of year and turns out it wont work. So my wuestion is what year warrior frames are conpatible with the 01's.
  5. F

    rebuild/jetting question

    When rebuilding a engine(bigger bore) is it required to install bigger jet to compensate? (New to rebuilds)
  6. F

    how to remove air from my oil injection lines??

    just got my blaster all sealed up again (was havin airleak issue) but when hooking oil injection lines back up i noticed air bubbles in the main line leading to pump. Whats the easiest way i can remove these bubbles or if its not necassary let me know.
  7. F

    not enough fuel

    clean out ur carb and take petcock out and clean it real good. seems like theirs blockage somwhere
  8. F

    blaster not getting enough power

    did u leak test? 300 seems big for stock but id rather run rich and lose a bit of power then run lean and pay for a rebuild.
  9. F

    Whats the highest cc's i can get on my blaster?

    warrior are nothing to beat i have blaster and warrior and the warriors are all low end torque. the riders ability is what determines alot of it.
  10. F

    how to replace bottom end seals??

    finally got the motor all done. had air leak right at the carb boot sealed the up and held pressure. Time to rip
  11. F

    how to replace bottom end seals??

    dont have oil coming out of vent tube, i have air coming out. i leak tested previously to the new seals. after installing seals i had misfourtune of hitting a deer at 40 mph on my gas saver(scooter) so havent been able to work on it since
  12. F

    yz85 Blaster at Sunset Ridge MX

    a yz 85 motor in a blaster? first ive seen that. looks like it rips pretty good
  13. F

    Is this blaster worth buying?....

    i would buy it. the kick starter shaft is easy fix along with new shifter. since its torn apart the clutch is right there and thats easy as hell. id make sure u got good compression and spark before buying though.
  14. F

    At my wits end

    hows the timing on crank and idler? theres 2 dots on each gear that need to be lined up with each other.
  15. F

    think im missing somthing

    just silicone it and your good to go
See more
Top Bottom
Back