Sorry, multiple replies.....
I did not have to change anything, this bolted directly into place. But only because I had already deleted the TOR's system. If you still have the TOR system you will need to remove for this carb to work.
It's not a Yamaha carb if that's what you are asking. It is made by Mikuni and seems to be quite good regarding quality. however this carb only works if you have already delete the TOR's system.
have you deleted the TORs system? if you were already running a Chinese carb then I would assume yes but it's better to confirm.
I'm running this carb...
I have a 98 blaster. Engine is stock but I have done a handful of upgrades. TORS system deleted last season along with oil inject system. New reeds last season.
Ran great all last season. Stored for winter with fuel stable and an empty carb. Pulled out a couple weeks ago and can't get the...
I have a 98 blaster. Engine is stock but I have done a handful of upgrades. TORS system deleted last season along with oil inject system.
Ran great all last season. Stored for winter with fuel stable and an empty carb. Pulled out a couple weeks ago and can't get the thing to drive. It dies...
SOLVED!!!
It was not related to the carb. I failed to disconnect the TORS system in all location. I only cut the wires from the old carb cap and left the rest connected assuming it had been deactivated. I cut the wires coming from my thumb throttle and then disconnect the black box on under...
Yes, I tried adjust the air/fuel screw and it had no effect on idle quality. I did notice the engine became less responsive as the mixture got richer. Same with the choke, it become less responsive with the choke on.
First Post: I've been lurking for a bit since I just bought my blaster and there is a lot of great support here. I'm in need of some help please.
97 Blaster. completely stock to my knowledge when I purchased. After purchase I immediately deleted the oil injection pump and just filled with...