Recent content by blastersfaster

Hey man in not to smart with these things but I was having the same symptoms you were after I built mine it would start first like but idle like sh*t requiring a little gas and bogg down with to much. Every jet I tried maid no difference more unplugging tors. after a while I replaced my key way...

Make sure you have a good ground it should be connected to the frame by the spark plug coil.

You should check out jetsrus.com they are pretty cheap for stock and oem replacements

There were no directions. I chose to keep the stops just as a precaution. BTW that was the last step for my build after testing it started up third kick. And so far runs like a dream. As soon as I figure out how to put pics up I'll post them

I was thinking the same thing about them breaking. Thnx.

Kinda confused here in dealing out the stock reeds for double stage. Do I keep the reed stopper's or leave them out

1 1\8 expandable boat plug from the hardware store. But it won't work in the manifold flange you have to put it in the exhaust port

Another question the crank is a new weisco crank, it sis not come with its own key so I used the stock and that's were I came into problems I think. So I'm wondering if weisco supplies these has any body used this crank did the stock key worked I just went to the hardware store and bought five...

I tried everything nothing worked so I took a fifty fifty chance and drilled it. Got lucky got er out of there without toasting it

That's what I been trying but it started to chip away at the little material Sticking up

The flywheel key is stuck in the shaft and i cant get it out . Seems like it sat all the way down maby i didn't line it up correctly and pushed it in there myself whene I put it on. Any suggestions on how to get it out? Its almost sitting flush.

So bigger jet has no effect clip position either. Bought a compression tester wala found my problem I think 110 is way too low Wright? I should have done this alot sooner I know but like the title said im lost. I'm gonna replace the reeds first I took them out and seems they don't sit all the...

Both air and fuel filters are new.needle clip is on second groove I tried the third last night and a ton of diff jets float level is good oil sert is plugged on carb and pump I only removed the plastic gear on the oil pump and blocked the holes. Should I have done more? The jet washer is in...

Yes a couple times and replaced everything with rebuild kit I think after work today before i pull the fly wheel i will try the biggest jeti have 350 just to see

New b8es plug new premium Gas 32-1mix, did the lleak down test stayed at 8 psi gor around 7 minute I did not clean the petcok I will tonight should I have a bigger filter on it now that I'm running premix or is the regular little inline fuel filter enough or should I even have one on there. It...