Recent content by Blastahmastah1

My iphone wont allow me too download for some reason no biggy though.

Will do! Ill do some tinkering an see what results

Appriciate it. I need to know how to break down the mechinism inside the caliper, i cant find anything so ill try to make a step by step on how to rebuild the mech.

Has anybody have any info on rebuilding the caliper on the cable rear brakes??? The flat washer bearing deal went out so i need to replace it an i have one on the way. Not trying to convert to hydros just trying to stop.

Yea i got one right by an shes got some compression so a rebuild is highly doubtful in this situation but ya never know...

Ifr the bog seems the be around 3-4th gear 1/2 throttle, i dont have any filter oil an ways but yea ill have to look into the recharge kit cause id hate to throw a 50$ filter away. Will peform a plug chop real soon ganna find my jets tomorrow

Well shes hauls ass now! My clean airfilter with my airbox mod seem to have worked but ganna have it properly jetted before i ride her hard cause it still has a bog goin on but the powerbands back!

I shure will there cheap from what ive heard 3$-5$

Well that settles it ill just run to my nearist motoshop an grab me some jets an update yall from there if anything changes

Ive only owned the bike for a week so honestly its never fouled a plug on me its just my experiance with my several other 2 smokes i run 9's an they love um, oil injection nipple is blocked off, yea purple power soapy water an compressed air i used to clean the filter, you could eat off the carb...

Yea that sucks, i have my snorkel on i just drilled six 1/2 holes in the lid, i cleaned it once an put it on my bike but it was still boggy but i used purple power an dish soap so hopefully all the debris is out of the filter

Yea ive been scrubbing my k&n to get all the crap out of it ganna see it it runs better with my lid mod i did, probably just ganna get a foam filter cause this thing still feels restrictive

Bahhah well after several carb tear downs, cussing an cigarettes i finally found the problem....... I seem to have misjudged the dirtyness of my airfilter...... Lol

I set it at 20.75mm, i also noticed my needle valve has a small ring indented into the rubber part would this contribute to my problem

So I adjusted the float valve an it ran a but better but still not running right Nuetral it revs up fine through the rpm range like it has but not under load.... Reeds look brandnew an flat... I also noticed putting the bowl back on the carb is a pia an when i shake the carb there doesnt seem to...