Recent content by Benjamin wagar

  1. B

    Blaster won't rev in gear

    Ok got it to run great did plug chop and everything ended up with 2 3/4 turns out on air screw. Runs like a raped ape now thanks for all the help
  2. B

    Blaster won't rev in gear

    Ok got it to run great did plug chop and everything ended up with 2 3/4 turns out on air screw
  3. B

    Blaster won't rev in gear

    Ok so 290 main jet air screw 1.5 mad sure float level is in speck and needle Is good runs good atlow to mid rpm but still kinda boggy at mid to mid high and I have to give it medium throttle if I pin it it just boggs like bad but if I stay mid throttle it pulled out of bogg at mid and revs good...
  4. B

    Blaster won't rev in gear

    Ok I feel like an idiot I took carb apart and checked every thing then checked float level and it was way off so set it to correct level 21mm and runs great now.
  5. B

    Blaster won't rev in gear

    So I removed the teather completely and realised I didn't do the full tors till of read the post on how to splice the wires to fool ecu. But it still bogs bad in first and second. Will eventually rev hi in 3 4 but cuts out in 5 and 6
  6. B

    Blaster won't rev in gear

    Ok so got the tors delete kit and installed it put 280 jet in and it runs and can go through gears but not like it should 1st and 2nd are crap no low end at all have to putt 3 4 5 6 are better low end and some top end but it cuts out like it's getting killed till I let off then it's fine and if...
  7. B

    Blaster won't rev in gear

    Ok so ordered the tors delete kit once it arrives will install that and the 300 jets
  8. B

    Blaster won't rev in gear

    So I took the carb apart and it was a 360 jet in there have not gone and got 300 and 280 jets yet and haven't tried to state it either
  9. B

    Blaster won't rev in gear

    Ok It's d stock airborne and air cleaner and won't start it till get 300 jets
  10. B

    Blaster won't rev in gear

    OK so I should put the bigger one in I think it's a 350 or 60 not sure have to look
  11. B

    Blaster won't rev in gear

    Ok yes used needle from jet kit using the 230 jet. No didn't do leak down test will do the and been looking in to the tores
  12. B

    Blaster won't rev in gear

    Yes it is I tried to by pass it by using a jumper and didn't change.
  13. B

    Blaster won't rev in gear

    So I have a 06 blaster that I just put new pistons and jug on did proper break in. And went to get on for first time to ride and run first tank through it and put it in gear and start out fine give it any throttle and just boggs bad let off and will idle and put along. Revs good till bout 4000...