Recent content by beaten blaster

  1. B

    Looking for left and right side cases or good completle bottom end.

    i have both cases...also have hot rod crank,stator,all gears,kickstart gear,cylinder(not sue of bore)gaskets etc
  2. B

    questions about tools

    i found a 33 gal electric upright with wheels.it's a craftsman and it's only like $240.00 at my local sears store..i think i might just jump on that for now.
  3. B

    questions about tools

    i do have a small air compressor but i think it might be too small.its a craftsman 3 gallon pancake compressor.thats why i was kind of leaning toward electric.i already have a dremel,19v craftsman drill and basic tool sets and socket sets.i was also leaning toward electric because the only...
  4. B

    questions about tools

    i am making my christmas list for wifey.and i am looking into getting a few new tools for around the house and to help with the blasty..first i am looking into a impact driver possibly cordless but i know nothing about torque power speed etc..next is a blind bearing puller with hammer i think...
  5. B

    cleaning the cases

    thanks guy's... i will use some brake cleaner and some elbow grease :D
  6. B

    cleaning the cases

    from talking to awk and ken i finally got my motor fully apart and all tbe bearings and seals out I:I my next question before i go any further is what can i safely soak my case half's in to clean them up and get the grime out?the cases have been sitting a while so there dirty and im looking to...
  7. B

    transmission disassembly

    Done I:I ..rep given thanks again for taking time out of your busy schedule to help "the little guy"
  8. B

    transmission disassembly

    Yes I have ken..they are very helpful..thank you so much
  9. B

    transmission disassembly

    ken i finally got it out..i saw videos that show the clip on the outside..thats why i could not figure it out there was no clip there..when i got the gears out the clip was behind the gears on the inside.why was that?another good reason to always go through the motor for this reason
  10. B

    transmission disassembly

    any ideas?i keep reading the clymer and nothing?what am i not getting?
  11. B

    transmission disassembly

    my finger is on the pin i cannot get out
  12. B

    transmission disassembly

    i have a second bottom end i am going to rebuild as a back up motor.i have finally got the cases split and currently trying to get the transmission out to replace all bearings and seals..i looked at the clymer book and it shows how but i still cant figure it out..i see the two dowel pins that...
  13. B

    04 blaster wont rev on brand new rebuild

    whoa whoa...first off you stated 230 main?and your jug is ported? :o way to lean could be starving for fuel.up the main jet
  14. B

    FS:K&N Prefilter,Outerwears airbox lid,Case saver

    Still have that case saver?does it come with the mounting bolts?
  15. B

    New Handel Bars

    it will make it easier for everyone if you post pics of what your selling I:I